3x Top lights BLUE on support Version A 1:32 452153 Categories;Featured Products There are 8 taillight covers

There are 8 taillight covers in this set

THE TIRE WILL THEN EASILY FITS

PVA or wallpaper paste is not recommended by the manufacturer

Each top light has a pin on the bottom that you can use to drill/glue into the roof of your model

It comes with different Sieve sizes for creating a varied effect using 2-12 mm lengths of Static Grass

3x Top lights BLUE on support Version A 1:32 452153 Categories;Featured Products There are 8 taillight covers3x Top Lights on Support 1: 32 Tip: The top lights are 3D printed on a black strip, and each top light is finished with a clear glitter. Each top light has a pin on the bottom that you can use to drill glue into the roof of your model. (See example photos on the Johan Deere.) These top lights can also be installed without drilling. Simply cut break off the pin on the bottom and run the top light over a piece of sandpaper. This will ensure it stays