Holley EFI - Hall Effect Crankshaft Signal Sensor Hose and Wire Sleeve -

Hose and Wire Sleeve - Firesleeve - 7/8 in ID - 3 ft - Silicone / Fiberglass - Red - Each

Air Induction System - Momentum GT - Reusable Oiled Filter - Plastic - Black - Jeep V6 - Dodge Durango 2016-25 / Jeep Grand Cherokee 2016-21 - Kit

50 in OD - C3-R4 Valve - Steel - Black Paint - Rear - GM A-Body / G-Body - Each

1 - 50 in Length - Pull Down Adjust - Bolt-In / Wrap Around - Individual Harness - HANS Ready - Black - Kit

Our universal AEM FPR is tapped to accept a -6 AN

Holley EFI - Hall Effect Crankshaft Signal Sensor Hose and Wire Sleeve -Designed as a drop in sensor replacement for flying magnet crank trigger setups using a 16 threaded magnetic sensor. This sensor is a hall effect sensor, meaning it outputs a square wave signal, which is ideal for use with most electronic fuel injection systems. This sensor is to only be used with a trigger wheel with flying magnets. It does not detect a ferrous steel target. The sensor can operate from 5 20 volts. It is recommended to feed the sensor