Link ECU Bosch LSU 4.9 (5 Wire) - (LSU49) Professional ECU Loom Customizable Screens

Customizable Screens

Coolant Temperature sensors (NTC1-8) and other sensors that use 1/8" NPT Thread

coolant temperature

Pin Description 1 Ignition Feedback - Not required for standalone ECU (IGF) 2 Ignition Signal from ECU (IGT) - Link ECU Connector A - Pin 13 3 Ignition switched 12V+ Power (15amp AM2 fuse) (B+) 4 High side output to drive tachometer (TACH) 5 Goes to Ignition Coil - Pin 2 (C-) Looking into the front of the connector

Up to 6 widgets per page

Link ECU Bosch LSU 4.9 (5 Wire) - (LSU49) Professional ECU Loom Customizable ScreensThis sensor can be used with all wide band controllers and ECUs that support LSU 4. 9 sensors. This includes: Link G4+ G4X Fury and G4+Thunder ECUs These have on board LSU4. 9 wide band control. Link CAN Lambda Controller These are sold new with a sensor, so this sensor by itself is only required if you need a replacement. Specifications: Application: lambda 0. 65 to Exhaust gas temperature: 930C (1,030 for a short time) Hexagon temperature: 600C